Today I got error 1603 while installing Autodesk Revit 2019 on a student’s laptop. The best solution is to uninstall all Microsoft Visual C++ runtimes, reboot the computer, and let the Revit installer get its way installing the supplied versions.
cc0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500 options=ec07bb<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,JUMBO_MTU,VLAN_HWCSUM,TSO4,TSO6,LRO,VLAN_HWTSO,LINKSTATE,RXCSUM_IPV6,TXCSUM_IPV6> ether 00:07:43:XX:XX:X0 hwaddr 00:07:43:XX:XX:X0 nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL> media: Ethernet 10Gbase-SR <full-duplex,rxpause,txpause> status: active
Boot messages for
t6nex0: <Chelsio T6225-CR> mem 0xfac80000-0xfacfffff,0xf9000000-0xf9ffffff,0xfaff6000-0xfaff7fff irq 16 at device 0.4 on pci6 t6nex0: firmware on card (184.108.40.206) is older than the version bundled with this driver, installing firmware 220.127.116.11 on card. cc0: <port 0> on t6nex0 cc0: Ethernet address: 00:07:43:XX:XX:X0 cc0: 4 txq, 4 rxq (NIC); 4 txq, 2 rxq (TOE) cc1: <port 1> on t6nex0 cc1: Ethernet address: 00:07:43:XX:XX:X8 cc1: 4 txq, 4 rxq (NIC); 4 txq, 2 rxq (TOE) t6nex0: PCIe gen2 x4, 2 ports, 14 MSI-X interrupts, 31 eq, 13 iq pci6: <mass storage, SCSI> at device 0.5 (no driver attached) pci6: <serial bus, Fibre Channel> at device 0.6 (no driver attached)
The firmware was in need of an upgrade. Continue reading Chelsio T6225-CR has arrived
The aim is to get a 10 Gbit/s connection to the LAN, utilise the off-load capabilities of the NIC, and of course utilise the on-board crypto accelerator. The latter will not be useable until the system moves to the upcoming
stable/12, I look forward to encrypted crash dumps and linear ZFS scrubbing.
I hope both OpenSSH and OpenSSL will be able to use the crypto accelerator by ways of
crypto(4). Imagine a crypto speed in excess of 30 Gbit/s. That’s pretty neat. If all goes well, another T6225-CR may find its way to a VPN router.